Install the FBDIMM.
7.
Install the memory board
8.
Install the processor air baffle.
9.
Install the access panel (on page 26).
10.
Do one of the following:
11.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
If you are installing FBDIMMs in an online spare or mirrored memory configuration, use RBSU to
12.
configure this feature
Hot-plug hard drive options
When adding hard drives to the server, observe the following general guidelines:
•
The system automatically sets all device numbers.
•
If only one hard drive is used, install it in the bay with the lowest device number
device
numbers" on page 15).
•
Hard drives must be SFF types.
•
Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
("Removing and installing a memory
("Configuring online spare
board" on page 47).
memory" on page 83).
Hardware options installation 50
("SAS and SATA