Removable Media Device Options; Installing Media Devices With Rails - HP ProLiant ML100 Series User Manual

Removable media device options

Depending on the model, ProLiant 100 Series servers require different installation procedures for media
devices.
Server
ProLiant ML110 G2 Server
ProLiant ML110 G3 Server
ProLiant ML110 G4 Server
ProLiant ML110 G5 Server
ProLiant ML115 Server
ProLiant ML115 G5 Server
ProLiant ML150 G2 Server
ProLiant ML150 G3 Server
ProLiant ML150 G5 Server

Installing media devices with rails

NOTE:
installing the media device into the server, refer to the installation sheet for your specific server.
Power down the server (on page 6).
1.
Extend the server from the rack, if applicable.
2.
Remove the access panel
3.
Access the removable media cage.
4.
Remove the bezel blank.
5.
NOTE:
Depending on the server, obtain the screws from one of the following locations:
6.
Bezel blank
o
Chassis
o
Accessory kit
o
Device support
Half-height and full-height
Half-height
Half-height
Half-height
Half-height
Half-height
Half-height
Half-height and full-height
Half-height and full-height
This process only represents one installation method. For specific instructions for
("Access panel" on page 11).
HP recommends that you remove all bezel blanks to facilitate drive installation.
Procedure
Installing media devices with a media latch (on
page 37)
Installing media devices with screws (on page
35)
Installing media devices with screws (on page
35)
Installing media devices with screws (on page
35)
Installing media devices with screws (on page
35)
Installing media devices with screws (on page
35)
Installing media devices with rails (on page 34)
Installing media devices with screws (on page
35)
Installing media devices with wire retainers (on
page 38)
Hardware options installation 34