Mounting The Operation Panel (Fr-Du07) On The Enclosure Surface - Mitsubishi Electric FR-A720-0.4K Instruction Manual

Wiring of the control circuit of the 75K or higher
For wiring of the control circuit of the 75K or higher, separate away from wiring of the main circuit.
Make cuts in rubber bush of the inverter side and lead wires.
Rubber bush
(view from the inside)
Make cuts along the lines inside with
a cutter knife and such.
2.4.9

Mounting the operation panel (FR-DU07) on the enclosure surface

Having an operation panel or a parameter unit on the enclosure surface is convenient. With a connection cable, you
can mount the operation panel (FR-DU07) to the enclosure surface, and connect it to the inverter.
Use the option FR-CB2
Securely insert one end of connection cable into the PU connector of the inverter and the other end into the
connection connector of the operation panel (FR-DU07) along the guides until the stoppers are fixed.
Operation panel(FR-DU07)
CAUTION
Do not connect the PU connector to the computer's LAN port, FAX modem socket or telephone connector.
The inverter and machine could be damaged due to differences in electrical specifications.
REMARKS
⋅ Refer to page 6 for removal method of the operation panel.
⋅ When using a commercially available connector and cable as a parameter unit connection cable, refer to Chapter 2 of
Instruction Manual (Applied).
⋅ The inverter can be connected to the computer and FR-PU04/FR-PU07.
, or the following connector and cable available on the market.
Parameter unit connection cable
(FR-CB2 )(option)
Operation panel connection connector
(FR-ADP)(option)
Wiring
<Wiring>
2
the
25