Drive.system.electronic.board.disassembly/Assembly - Advance acoustic Adfinity 17ST Pressure Washer

DRIVE SYSTEM ELECTRONIC BOARD DISASSEMBLY/ASSEMBLY (For Adfinity
20 C, X 24 D)
Disassembly
1. Disconnect the battery connector (12).
2. Move aside the recovery water drain hose (16).
3. Remove the battery charger cable (6) from the cable holder (7).
4. Remove the screws (A) and carefully move aside the panel (B) by disengaging the cable grommet (C) from its housing on
the panel (B).
5. Disconnect the connectors (D), (E), (F), and remove the panel (B).
6. Disconnect the connectors (G) of the drive system electronic board (H).
7. Remove the screws (I) and move the electrical panel (J) by disengaging it from the lower fastener (K).
8. Remove the screws (L) on the rear side of the electrical panel (J), then remove the drive system electronic board (H).
Assembly
9. Assemble the components in the reverse order of disassembly.
E
D
B
A
B
A
A
Adfinity
F
A
C
S301573A
17 ST, 20 ST, 20 D, X 20 D, X 20 C, X 24 D
TM
SERVICE MANUAL
ELECTRICAL SYSTEM
L
L
J
I
H
G
G
K
9096982000(1)2007-02
ENGLISH
20 D, X 20 D, X
TM
J
I
S301574A
59