Brushing System; Brush/Pad.cleaning - Advance acoustic Adfinity 17ST Pressure Washer

BRUSH/PAD CLEANING
CAUTION!
It is advisable to wear protective gloves when cleaning the brushes/pads because there may be sharp debris.
1. Remove the brushes/pads, as shown in the User Manual.
2. Clean and wash the brushes/pads with water and detergent.
3. Check that the brush/pads are integral and not excessively worn; otherwise replace them.
4. (For.Adfinity X 20 C) Remove the debris container (A) by pulling it on one side with the handle (B). Empty and wash the
TM
debris container (A), and then install it by engaging it on the inside fasteners.
BRUSH/PAD-HOLDER BRUSH DECK DISASSEMBLY/ASSEMBLY (For Adfinity
The machine can be equipped with either the brush/pad-holder deck or the cylindrical brush deck.
Disassembly
1. Drive the machine on a level floor.
2. Remove the brushes/pad-holders, as shown in the User Manual.
3. Lower the brush/pad-holder deck by pressing the pedal (11).
4. Disconnect the brush/pad-holder motor electrical connection (A).
5. Remove the screw (B) and disconnect the electrical connection (C).
6. Disconnect the solution hose connection (D).
7. Remove the screws (F), then remove the brush/pad-holder deck (E).
Assembly
8. Assemble the components in the reverse order of disassembly.
Adfinity
A
B
F
17 ST, 20 ST, 20 D, X 20 D, X 20 C, X 24 D
TM
SERVICE MANUAL
B
A
D
E
C
9096982000(1)2007-02
ENGLISH

BRUSHING SYSTEM

S301529A
17 ST - 20 ST)
TM
S301530A
23