Plated Finish Maintenance; Disposal Of Ashes; Refractory Replacement - Enerzone Solution 2.5ZC Installation Instructions Manual

Hide thumbs Also See for Solution 2.5ZC:

Table of Contents

2.3.5 Plated Finish Maintenance

Use a metal polish and a soft cloth to clean the plated finishes. Do not use abrasives such as

steel wool, steel pads or an abrasive cleaner for they may scratch the finish.

Do not attempt to clean the fireplace when the unit is hot. Ashes should be placed in a metal

container with a tight fitting lid. The closed container of ashes should be placed on a non-

combustible floor or on the ground, well away from combustible materials pending final

disposal. If the ashes are disposed of by burial in soil or otherwise locally dispersed they

should be retained in the closed container until all cinders have thoroughly cooled. Do not

attempt to clean the stove when the unit is hot.

Note: The fan should be turned in "OFF" position prior to ash removal to avoid ashes to be

pulled towards the fireplace and then pushed into the room.

The intense heat of the fire will normally cause hairline cracks in the refractory. These cracks

can be minimized by proper curing as described in "First Fires". They will not normally

diminish the effectiveness of the refractory. If large cracks develop, then the refractory should

be replaced. To replace the refractory bricks, follow these steps:

1. Remove the andiron (A) held in

place by the two torx screws (B).

2. Remove the brick retainers (C)

3. Remove the left side bricks (D)

4. Remove the right side bricks (E)

5. Remove the rear bricks (F)

6. Remove the bottom brick (G)

To install the new bricks, follow the

above steps in reverse.

Figure 3

Table of Contents