Orban Optimod-PC 1101 Operating Manual page 81

OPTIMOD-PC
The R
until you explicitly close it by clicking D
B) Calibrate using tone—feed a test tone at your reference level to OPTIMOD-PC.
[Skip this step if you are using program material to calibrate OPTIMOD-
PC to your standard studio level. Skip to step (C) on page 2-29]
a) If you are not using a studio level controller, feed a tone through your
console or mixer at the level at which you normally peak program material
(typically 0 VU if your console uses VU meters).
If you are using a studio level controller that performs an AGC function,
such as another OPTIMOD-PC or an Orban 6300, adjust it for normal
operation.
b) In the I/O Mixer, click the C
c) Click the P
d) Set the A
–20dBfs.
For more information, refer to the notes under step 1 on page 2-26.
e) Note the setting of the A
and set the A
f) Skip to step 5 on page 2-30.
C) Calibrate using program: Feed normal program material to OPTIMOD-PC's
analog input.
[Skip this step if you are using tone to calibrate OPTIMOD-PC to your
standard studio level—see step (B) above.]
a) Play program material from your studio, peaking at the level to which you
normally peak program material (typically 0 VU if your console uses VU
meters).
b) In the Mixer application, click the C
c) Verify that AGC is set to E
Refer to step (0 on page 2-20.
d) Click the P
e) Set the A
the main meter screen in the Orban Control application) indicate an
average of 10 dB gain reduction when normal levels are applied to the
OPTIMOD-PC's analog input.
If necessary, drag the Mixer window so that the AGC G
ter is visible.
preset becomes active. The dialog box remains open
-M
OCK EDIUM
ONFIGURATION
tab.
ROCESSOR MIXER
L/R I fader to make the M
NALOG NPUT
NALOG
L/R I fader to the same value.
NALOG NPUT
NABLED
M tab.
ROCESSOR IXER
L/R I fader to make the AGC G
NALOG NPUT
.
ONE
tab.
O
IXER
L/R I fader. Click the D
NPUT
tab.
ONFIGURATION
.
AIN
AIN
INSTALLATION
meter indicate
UTPUT
M tab
IRECT IXER
R meter (on
EDUCTION
me-
R
EDUCTION
2-29