Table of Contents
Advertisement
OPTIMOD-PC
2. Select the card you are setting up.
A) From the Connect menu on the Control application, select the card you are
setting up by connecting to it.
If you have only one card installed in your machine
and you open the OPTIMOD-PC application from the
agent, you do not need to connect manually
because you will automatically be connected to this
card already.
If you wish, you can edit the factory default
Input/Output ("IO") setup. You also have the option
to O
S
PEN
application's F
• You can save your current setup to a file and then apply it to another card.
• You can load a previously saved setup into the card that is currently se-
lected.
B) To copy an IO setup from a source card to a destination card (optional):
a) If you have not already saved the IO setup you wish to apply to the
destination card, use the Orban Control application to connect to the
source card. Then go to F
card.
When saving, use any legal operating system filename other than
fault.orbfs
A given card's setup is stored in the Registry on the computer where that
card resides.
The current active setup file is always the last file that was recalled by the
F
/O
ILE
way, the current active setup is stored in a file named
The current active setup file is a transient file. That is, the Orban Control
application updates it whenever you change the setup manually. The
Orban Control application also automatically updates the file when the
application starts and reads the setup information from the Registry. You
cannot assume that a *.orbs setup file (other than
static or that it will retain its original information.
The factory default system setup is stored as
read-only file. It is the only system setup file that is static and unchang-
ing. For further security, it is automatically regenerated each time the
Orban Control Program or Service starts up.
b) Connect the Orban Control application to the destination card.
c) Go to F
ILE
d) Navigate to the folder containing the setup file you wish to retrieve.
This will usually be the file you saved in step (a).
or S
S
ETUP
AVE
ETUP
menu. Therefore:
ILE
/S
ILE
AVE
, which is a reserved name. Setup files have the form
operation. If you have never recalled a setup file this
S
PEN
ETUP
/O
S
.
PEN
ETUP
A
in the Control
S
S
and save the IO setup of the source
ETUP
system.orbs.
default.orbfs
INSTALLATION
de-
.
*.orbs
default.orbfs
)is
. This is a
2-19
Advertisement
Table of Contents
