Mount Optimod-Pc In A Free Pci Slot In Your Computer; Install Driver And Software - Orban Optimod-PC 1101 Operating Manual

2-2
INSTALLATION
of purchase. Please fill in the Registration Card and send it to us today.
(The Registration Card is located after the cover page).
We do not sell our customer's names to anyone.

2. Mount OPTIMOD-PC in a free PCI slot in your computer.

OPTIMOD-PC should be compatible with most IBM-compatible computers
as long as they do not use PCI-X or require low-profile PCI cards. The
computer's PCI bus must be Plug & Play PCI Version 2.2 compliant, 32-bit,
33MHz, with a transfer rate up to 132MBytes/sec. OPTIMOD-PC will oper-
ate in a 3.3V or 5V PCI slot, and with bus expansion. More than one
OPTIMOD-PC card can be installed in a given host computer.
Remove AC power from the computer. Using proper static control proce-
dures, remove OPTIMOD-PC from its anti-static packaging bag and insert
it in a free PCI slot in your computer.
If you are installing more than one OPTIMOD-PC card, insert all cards at
this time.

3. Install driver and software.

A) Apply power to your computer and let it boot.
After most of the normal boot process is finished, the Windows "New
Hardware Detected" wizard will appear.
B) Click Cancel as many times as necessary to close the "New Hardware De-
tected" wizard.
When you run the Orban installer according to the instructions below, it
will automatically install the correct driver.
C) (Optional) If you have installed more than one card, Windows will continue
to present "New Hardware Detected" windows until you have installed all
cards. Continue to cancel out of the "New Hardware Detected" wizard until it
no longer appears.
D) Insert your OPTIMOD CD-R in your computer's CD-R reader.
E) Navigate to Start/Run on your computer. In the Run dialog box, type
where "x" is the drive letter of your CD-ROM drive, and click "OK."
This will install the 1101's driver and its control and server software on
your computer. The server runs as a Windows service and will automati-
cally run at boot time.
IMPORTANT: Your computer must be rebooted to load the new driver
before you can use your newly installed cards. The installer will offer to
reboot your computer automatically at the end of the installation.
F) Answer the questions when prompted by the Orban installer.
The installer will allow you to create a desktop icon pointing to the
OPTIMOD-PC control application and will allow you to create an "agent"
in the System Tray that launches the OPTIMOD-PC control application via
a single click.
ORBAN MODEL 1101
,
x:setup