Orban Optimod-PC 1101 Operating Manual page 154

3-58
OPERATION
sets. Table 3-4: Equalization Controls on page 3-27 shows the controls that must
be set identically in all anchor presets.
You must create at least two anchor presets, one for L
for L = 10.0. Additionally, if the default L
-M
ESS ORE
step 3 is neither 1.0 nor 10.0, you must create a third anchor preset for the de-
fault L -M value.
ESS ORE
You may add as many additional anchor presets as you wish to fine-tune the be-
havior of L
-M
ESS ORE
sets.
From the OPTIMOD-PC Control Application, save each preset as a user preset in
plain text (unencrypted) form, naming it
the L setting that corresponds to that preset. For example, for L
-M
ESS ORE
M = 1.0, = 010.
xxx
ORE
5. Copy the user presets you made.
Copy these presets in the
folder that you made in step 2.
set\
6. Edit the file extensions.
In Windows, change the extension of each of your preset's file names to
7. Edit the text within the preset files.
A) In turn, open each of your preset files in a text editor like Notepad or Word-
Pad. The editor you use must open and save files in plain text format.
B) Edit the second line of the file as follows:
Preset Name=<MY PRESET LMxxx> size=126
where agrees with the file name
LMxxx
Do not change the number after
C) Edit the third line of the file as follows:
Factory Preset Name=<MY PRESET>
D) Edit the fifth line of the file as follows:
Preset File Name= <MY PRESET LMxxx.orbf11>
where
MY PRESET LMxxx.orbf11
E) At the end of the file, find the "LESS-MORE" line and edit it as follows:
C:<LESS MORE>Cent:x;D:y;
Replace the "x" and the "y" with the file's associated L
See Table 3-12.
. Some Orban factory presets use as many as six anchor pre-
My Preset LMxxx
\Program Files\Orban\OPTIMOD-PC2\presets\My Pre-
size
is the same as the file name.
ORBAN MODEL 1101
= 1.0 and one
-M
ESS ORE
value you chose in
-M
ESS ORE
, where stands for
xxx
orbf11
data.
-M
ESS ORE
-
ESS