10.1.3 Communication setting contents
This section describes setting items and display contents for Communication Setting.
(2)
(4)
(4)
(1) Channel-Driver assign
(a) Assignment of communication drivers to channels
Communication drivers installed in the GOT can be assigned to channels.
Even without setting [Controller Setting] on GT Designer3 or [Communication Setting] on GT
Designer2, communication with controller is available by assigning channel No. with this
function.
(
10.1.4
(b) Changing the assignment of communication drivers to channels
Without using GT Designer3 or GT Designer2, the assignment of communication drivers to
channels can be changed.
(When change a communication driver, the alternative communication driver has to be
installed in GOT in advance.)
(2) Standard interface display BOX
Display the communication interface included as standard in GT15
There are the following 2 types.
RS232...For communicating with PC (GT Designer3 or GT Designer2), controller
USB.......For communicating with PC (GT Designer3 or GT Designer2)
(3) Extend interface display BOX
The name of the unit installed in the extend interface is displayed.
(Displays [None] when any unit is not mounted.)
For details of each uint, refer to the following.
8.1 Communication Unit
USB interface (Standard interface)
(2)
(5)
(5)
(3)
(5)
Channel-Driver assign operation)
GOT front face
(1)
.
Extend interface
GOT rear face
RS-232 interface (Standard interface)
10.1 Communication Setting
10.1.3 Communication setting contents
9
10
11
12
13
14
15
16
10
- 3