Selecting Or Changing Access Code - Miller Robotic Interface II Owner's Manual

10-5. Selecting Or Changing Access Code

NOTE
Access
Setup
Display
Press Mode
Select
OM-172 324 Page 36
Access code works only when a data card is inserted (see Section 9-1).
R a n g e
S e c u r i t y
>A c c e s s
M i g T y p e
Turn Power Off And Back On
And Access Security Display
E n t e r
A c c e s s
C o d e
Figure 10-5. Access Code Display
1
Co d e
>O f f
Increase
C o d e
>O n
A A A
Parameter
Select
Co d e
O n
>A A A
⇒
P r e s s
Increase/Decrease
To Set Code
Parameter Select
To Move
Indicator
Co d e
O n
>Z WX
⇒
P r e s s
2
>C o d e A A A
⇒
P r e s s
1 Code Display
With code off, access to the setup
displays is not restricted.
With code on, the operator must
know and enter the access code to
access or change any of the setup
displays.
2 Access Display
With a code set, this display ap-
pears when power is turned on
while holding the pulse panel Mode
and Parameter Select buttons.
Press Parameter Select button to
enter access code. When the cor-
rect letter is entered, the indicator
automatically moves to the next
character. When the final access
code letter is entered, the display
automatically changes to the initial
setup display.