Table of Contents
Advertisement
app en di x D
Communications Converter Cables
USB to 10-Pin IDC (MD-CC400-000)
The MD-CC400-000 is an in-line USB to RS-422 converter with integrated 10-pin IDC cable. This product
is used to communicate to a single
Motion Control MForce. The included
components will allow you to connect
the USB port of a PC* directly to the
10-Pin IDC Connector located at P2.
Supplied Components: MD-CC400-
000 Communications Converter
Cable, USB Cable, USB Drivers, IMS
Terminal Interface Software.
10-Pin Locking Wire Crimp
Adapter
An optional pin adapter is avail-
able to convert the 10-pin IDC connector on the Communications Converter Cable to a 10-pin friction
lock wire crimp interface used on the Plus
Adapter Part # .......................................................MD-ADP-H
* If your PC is already equipped with RS-422, the MD-CC400-000 cable is not required.
Electrical Specifications
Ribbon Cable Length
Mechanical Specifications
USB Cable
To PC USB
Length 6.0 ft (1.8 m)
Appendices
2
units.
MD-CC400-000 Specifications
BAUD Rate
Up to 115 kbps
Connectors:
USB
RS-422 Side
10 Pin 2mm IDC
6 feet (1.8 meters)
Power Requirement
Power from USB
Table D.1: MD-CC400-000 Electrical Specifications
1.0 in
(25.0 mm)
USB
0.875 in
(22.0 mm)
Figure D.2: MD-CC400-000 Mechanical Specifications
Optional Cables and Cordsets
Figure D.1: MD-CC400-000
3.75 in
(95.0 mm)
MD-CC400-000
www.imshome.com
USB to RS-422 Converter Cable
10-Pin IDC Connector
Cable Length 6.0 ft (1.8 m)
WARNING! DO NOT
connect or disconnect
the MD-CC400-
000 Communications Converter
Cable from MForce while power is
applied!
To MForce
A-15
Advertisement
Table of Contents
