Attaching The Handstrap - Honeywell MX8 User Manual

Attaching the Handstrap

Note: Either the trigger handle is attached to the MX8 or the handstrap is attached, not both. In the absence
of a trigger handle, the handstrap should be used at all times. The handstrap is pre-installed on a MX8
that is purchased without a trigger handle.
Tool Required: Phillips #1 screwdriver (not supplied)
1. Place the MX8 with the screen facing down, on a flat stable surface.
2. Attach the handstrap retainer bracket to the MX8 with the screws and washers provided.
3. Slip the Handstrap Clip into the bracket at the base of the MX8.
4. Making sure the closed loop fastener surfaces on the handstrap are facing up, slide the strap through the pin in the
bottom bracket and the clip.
5. Fold each end of the strap over so that the closed loop fastener surfaces mate evenly.
6. Test the strap's connection making sure the MX8 is securely connected to each end of the handstrap's connectors.
Check the closed loop fastener, retainer bracket and clip connections frequently. If they have loosened, they must be tightened
or replaced before the MX8 is placed into service again.
2-18
1. Handstrap Retainer Bracket
2. Handstrap and tethered stylus
3. Handstrap Clip