Supplying Power To The Chargebase; Inserting And Removing Terminals - Honeywell Dolphin 9900 User Manual

Supplying Power to the ChargeBase

Using a non-Hand Held Products power adapter voids your warranty and could result in serious
!
damage to the circuitry of the Dolphin ChargeBase.
1. Be sure the power switch on the power adapter is in the OFF position.
2. Plug the power cord into the power adapter.
3. Plug the power connector cable into the power connector on the back panel of the ChargeBase.
4. Plug the power cord into a standard wall outlet.
5. On the power adapter, turn the power switch to the ON position. The LEDs illuminate as the
ChargeBase powers up.
6. The ChargeBase is ready to begin charging terminals.

Inserting and Removing Terminals

1. To insert the terminal, hold the terminal with the bottom panel perpendicular to the base.
2. Slide the terminal into the well until the Dock LED lights solid green.
3. Charging begins immediately.
Note: To remove a terminal, grasp it firmly in your hand and lift it up and out of the terminal well. The LEDs for the
terminal well turns off.
12 - 4 Rev (a) 02
3/5/08
Dolphin® 9900 Mobile Computer
User's Guide–Preliminary