Installation Procedure - Toshiba Carrier RAS-12EKCV-UL Service Manual

10-1. Installation Diagram of Indoor and Outdoor Units
Air inlet grille
5
3
Batteries
2
Wireless remote control
Remark :
• Details of accessory and installation parts can
be found in the accessory section.
• Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (− ) positions.

10. INSTALLATION PROCEDURE

Filter
6
Filter
8
Flat head
wood screw
24 in. (600 mm) or more
only when unobstructed to
the front and both sides.
Before installing the wireless remote controller
2 Wireless remote controller
Hook
1
Installation
plate
Front
panel
Shield pipe
Conduit
4
Remote control holder
Vinyl tape
Apply after carrying
out a drainage test.
Saddle
Extension drain hose
(Not available,
provided by installer)
– 48 –
FILE NO. SVM-13071
For the rear left and left piping
Wall
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
Do not allow the drain hose to get slack.
Cut the piping
hole slightly sloped
downward.
Make sure to run the drain hose sloped
downward.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear
right
Bottom Rear
right left
Bottom left
Insulate the refrigerant pipes separately,
not together.
5/16 in. (8 mm) thick heat
resisting polyethylene foam
3 Batteries
Left