JVC LST0819-001A Instructions Manual page 75

A
Privacy Mask
B
Mask Settings
Note:
● The tilt angle where mask can be set is within 40 degrees from the horizontal position.
● To change the privacy mask position to upper area from horizontal direction, press the up button until the end of
the horizontal position, release the button, and press it again. Only the privacy mask will be moved to upper
area. This will set the privacy mask at the area above the shallow horizontal position.
● The mask will appear larger than when it is set. If some area that you wish to hide appear due to the camera
direction or zoom, set the mask larger.
● The default home position is outside the range of the privacy mask.
● When the [Adjustment] window is opened in the computer for the first time, ActiveX will be installed.
For specifying whether to activate the Privacy Mask feature.
When this is set to On , the privacy mask specified using the following
items will appear on the screen.
:
Memo
● When setting privacy mask, zoom will be at the Wide edge and [Digital
Flip] is set to Off .
This item adjusts the mask. Click this item to open the [Adjustment] screen.
To change the setting, first, enter [Operator Password] in the [Password]
screen. (A Page 44)
If the [Operator Password] was entered already to setting page of built-in
viewer, it will be displayed as 000000.
[Mask Settings] screen
E
[Save]
This saves the new settings.
[Delate]
This removes the privacy
mask of the specified mask
number.
[Brightness] screen
This item sets the brightness (color) of the mask.
0 is black. The larger the number is, the closer the color is to white. When
the number is 10 , the color is white. You can check the color at [Image].
[Setting value:0 to 10]
[Password] screen
Enter the Operator Password . (A Page 44)
A
[Adjustment], [Brightness], [Password]
tab
Each setting screen appears.
B
[Mask]
When Off is selected, mask will not be
displayed on the screen.
[Setting value:0 to 7]
C
[Size]
This item sets the size of the mask.
Use the [Shrink] or [Expand] button to set
the Hight or Width of the mask.
D [Position]
This sets the position to place the mask.Set
the moving speed in [Pan/Tilt Speed].
[Setting values:1 to 8]