Basic Settings1 - JVC LST0819-001A Instructions Manual

Basic Settings1

This page is for performing basic setting related to the network.
● This page can be used during access using admin .
● Click [Basic Settings1].
● Press the [OK] button to enable the new settings.
● If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the
entry will be denied. Press the [Cancel] button to restore the invalid entry to the current value.
Click
:
Memo
● You can open the [Basic Settings1] screen without going through Built-in Viewer by entering direct
URL address in the address field of Internet Explorer.
When the IP address of the camera is 192.168.0.2 for example, enter the URL below.
VN-V685U
VN-V686BU/VN-V686WPBU :http://192.168.0.2/cgi-bin/v686display.cgi?v686basicmenu1.html
Network
A
IP Setting
B
IP Address
C
Subnet
Mask
D
Default
Gateway
Time
E
Time
F
Time Zone
G
Pc time to
Camera
:http://192.168.0.2/cgi-bin/v685display.cgi?v685basicmenu1.html
For setting the DHCP client function. Connect the camera to a network
environment with a DHCP server when DHCP is to be enabled. If the DHCP
server does not exist when [IP Setting] is set to DHCP Enable , the camera
will start running with IP address 192.168.0.2 and subnet mask 255.255.255.0
in about 2 minutes after startup. (A Page 42)
For setting the IP address of the camera.
For setting the Subnet Mask of the camera.
For setting the Default Gateway of the camera.
Set as 0.0.0.0 when the Default Gateway is not set.
Displays the clock time of the camera.
The time transmitted by the camera is recorded in the JPEG header.
Discontinuity may occur in the JPEG header's time immediately before and
after changing the time.
For setting the time zone.
Click the [Set] button to set the time of the computer on the camera.
A
B
C
D
E
F
G