Accessories; Wiring The Receiver Unit; Precautions On Simultaneous Installation Of Wired Remote Controller And Wireless Remote Controller - Sanyo Big PACi 18 Series Technical Data & Service Manual

8-4. Accessories

No. Accessories
1 Receiver
2 Remote Controller
3 Remote Control Holder

8-5. Wiring the Receiver Unit

●
Wiring Diagram
Terminal Strip for
Wiring Remote
Controls
●
Connections
Connect the wires from the receiver to the remote control terminal strip on the indoor unit. (Polarity does not
matter)

8-6. Precautions on Simultaneous Installation of Wired Remote Controller and Wireless Remote Controller

By installing a wired remote controller, the wireless remote controller kit can permit dual remote control operation at
the same time.
(Up to 2 units of remote controllers – a wireless kit and a wired unit – can be installed.)
Dual remote control operation can control 1 or multiple air conditioners using several remote controllers.
CAUTION
(1) To assign the wired remote controller as the sub
unit, locate the address connector at the rear of
the wired remote controller PCB and disconnect it.
Reconnect it to the sub unit position.
(2) To assign the wireless remote controller as the
sub unit, locate the dip switch [S003] on the wire-
8
less receiver unit PCB. Set the No. 3 switch to the
ON position.
Quantity No.
1 4
5
6
1 7
1 8
Indoor Unit
2 White
Black
3
●
Be sure to determine the correct terminal numbers on the indoor unit when wiring
the remote controller. The remote controller will be damaged if high voltage (such
as 220 – 240 VAC) is applied.
●
The wireless remote controller kit components cannot be used for more than 1
indoor unit at a time. (However, separate receiver units may be used simultane-
ously.)
●
When a wireless remote controller kit and a wired remote controller are used
simultaneously, assign either the wireless remote controller or the wired remote
controller as the sub remote controller unit.
Accessories
AAA alkaline batteries
Users Manual
Truss Self-Tapping Screws
4 X 16
Cable clamp
Clamp fixing screw 4 X 12
Receiver PCB
DO112
Screw
Cable clamp
PCB Cover
8-4
Quantity
2
1
2
1
1
S003
Bit 3: OFF ON
ON
Receiver PCB
Adjustable
Corner Cap
Fig. 8-5