To Disable A Zone Or Device; Panel Disablements Over A Network - Notifier Fire Alarm Control Panel Operating Manual

5.1.1.1 To Disable a Zone or Device

This description is for a panel working in stand-alone mode.
Performing disablements over a network is described after this.
1 Use the or navigation buttons to highlight the zone to
be disabled/enabled and then press the
state. The user is now given the choice of disabling/enabling ALL
the zone alarms inputs (highlighted by default) or individual
devices for the selected zone. In the example opposite, zone 4
was selected and all the devices in that zone are listed together
with an indication of their individual current enabled/disabled
state - in this case all devices are 'Enabled'.
Note: Devices that are not zone alarm inputs can be disabled
individually. However, zone output devices, such as sounders,
cannot be disabled individually.
2 To disable/enable the entire zone (default selection) press the
Each press of the
or enabled. After disabling a zone or device(s), press the
to display the 'DISABLE' tab and view the disabled devices.
However, if the toggle function is used for a part-disabled zone
then, depending on whether any devices are not zone alarm inputs,
the 'part-disabled' state is retained, even though the
been pressed to toggle the state. Also, with any device in the list
highlighted pressing the

5.1.1.2 Panel Disablements over a Network

When disabling a zone on a network you will be prompted to enter a
panel ID number before the zone selection can be made. Enter the
panel ID number and then make the zone or device selection as for
a stand-alone panel (see above).
With any active disablements all the panels on the network display
the DISABLE tab with all the disabled devices listed.
997-670-000-2
www.notifierknowledge.com
key to change its
key toggles the state of the zone: disabled
key toggles its 'enabled/disabled' state.
key.
key
key has
Navigating the Panel Menus
OR
Operating Manual
Section 5 - 3