Bottom Cover Assembly - Toshiba QOSMIO G20 Maintenance Manual

4.8 Bottom cover assembly

4.8 Bottom cover assembly
Removing the bottom cover assembly
The following describes the procedure for removing the bottom cover assembly (See Figure
4-11 to 4-14).
1. Remove the following screw securing LCD harness cover and remove the LCD
harness cover.
M2.5x4.0B
2. Disconnect the LCD harness from the connector CN5000 on the system board.
3. Disconnect the RJ45 harness from the connector CN4100 on the system board.
4. Disconnect the Touch pad flat cable from the connector CN3201.
5. Disconnect the Volume harness from the connector CN3330.
6. Disconnect the Bluetooth flat cable from the connector CN4400.
7. Disconnect the Touch sensor flat cable from the connector CN3360.
8. Remove the following screws securing the cover assembly.
M2.5x8.0B
M2.5x4.0B FLAT BIND
LCD harness cover
M2.5x8.0B FLAT BIND
RJ45 harness
(Connected to CN4100)
LCD harness
(Connected to CN5000)
Figure 4-11 Removing the screws from cover assembly
4-24 [CONFIDENTIAL]
FLAT BIND screw
FLAT BIND screw
M2.5x8.0B FLAT BIND
Touch pad flat cable
(Connected to CN3201)
QOSMIO G20 Maintenance Manual (960-511)
4 Replacement Procedures
x1
x5
Bluetooth flat cable
(Connected to CN4400)
Volume harness
(Connected to CN3330)
Touch sensor flat cable
(Connected to CN3360)