Toshiba QOSMIO G20 Maintenance Manual page 132

3.3 Check of the RAID configuration
NO DRIVE for one drive is displayed
When "NO DORIVE" is displayed and the HDD is connected to the port, follow the
procedures below to check the HDD failure.
(1) Install a new HDD.
When "NO DORIVE" is still displayed, It is judged that the MB or cable fails.
(2) When a new HDD is recognized, It is judged that the HDD removed is failed.
Specify the reason by using the Independent Utility.
TOSHIBA RAID / RAID Information Display
Copyright(c) 2005 TOSHIBA CORPORATION. All Rights Reserved.
Level
LD0 RAID-1
Write cache
Degrade Bootup
MBR Protection
S.M.A.R.T
Port Assign Status
0 LD0-0
1
< RAID: not OPTIMAL >
3-14 [CONFIDENTIAL]
Status Capacity
DEGRADE xxGB
: Enable
: Yes
: Disable
: Enable
Size Model
ONLINE xxGB FUJITSU----------
NODRIVE xxGB FUJITSU----------
3 Tests and Diagnostics
Rev xx.xx.xxxx
Rev
xxxxxxx
xxxxxxx
QOSMIO G20 Maintenance Manual (960-511)