Touch Sensor Board - Toshiba QOSMIO G20 Maintenance Manual

4.30 Touch sensor board

4.30 Touch sensor board
Removing the touch sensor board
The following describes the procedure for removing touch sensor (See Figure 4-43).
1. Disconnect the touch sensor flat cable from the connector on the touch sensor board.
2. Peeling off the insulator, remove the following screws securing the touch sensor
plate and remove the touch sensor plate.
M2.5x4.0B
3. Pull up and remove the touch sensor board from the cover assembly.
CAUTION: The removed touch sensor board is not reusable. Therefore when installing
the touch sensor board, it must be a new one.
Touch sensor board
4-68 [CONFIDENTIAL]
FLAT BIND screw
M2.5x4.0B FLAT BIND
Insulator
Figure 4-43 Removing the touch sensor board
4 Replacement Procedures
x9
Touch sensor flat cable
M2.5x4.0B FLAT BIND
Touch sensor plate
QOSMIO G20 Maintenance Manual (960-511)