Toshiba QOSMIO G20 Maintenance Manual page 278

4.13 Optical disk drive
4. Remove the following screw securing the ODD side bracket and remove the ODD
side bracket.
M2.0x3.0C
5. Remove the following screws securing the ODD rear bracket and ODD relay board.
M2.0x4.0B
6. Remove the ODD relay board and ODD rear bracket from the optical disk drive.
ODD relay board
ODD rear bracket
M2.0x4.0B S-THIN FLAT BIND
Installing the optical disk drive
The following describes the procedure for installing the optical disk drive (See Figure 4-20
and 4-21).
1. Installing the ODD relay board and ODD rear bracket to the optical disk drive,
secure them with the following screws.
M2.0x4.0B
2. Installing the ODD side bracket to the optical disk drive, secure it with the following
screw.
M2.0x3.0C
3. Connect the ODD flat cable to the connector CN9680 on the ODD relay board.
4. Install the ODD assembly and secure it with the following screw.
M2.5x4.0B
4-36 [CONFIDENTIAL]
S-THIN FLAT BIND screw
S-THIN FLAT BIND screw
Figure 4-21 Removing the ODD rear bracket
S-THIN FLAT BIND screw
S-THIN FLAT BIND screw
FLAT BIND screw
4 Replacement Procedures
x1
x2
ODD side bracket
M2.0x3.0C S-THIN FLAT BIND
x2
x1
x1
QOSMIO G20 Maintenance Manual (960-511)