Toshiba QOSMIO G20 Maintenance Manual page 323

4 Replacement Procedures
Installing the LCD harness
The following describes the procedure for installing the LCD harness (See Figure 4-50 and 4-
52).
1. Arrange the LCD harness by putting the harness through the slot of display assembly.
2. Install the LCD harness holder (display rear cover side) to the display rear cover and
secure it with the following screw.
M2.5x4.0B
3. Installing the hinge front cap (L) while hooking the tabs, install the hinge rear cap
(L) and secure it with the following screw.
M2.0x4.0B
4. Install the LCD harness holder (cover assembly side) while holding the LCD
harness and secure it with the following screw.
M2.5x4.0B
QOSMIO G20 Maintenance Manual (960-511)
FLAT BIND screw
FLAT BIND screw
FLAT BIND screw
4.34 LCD harness
x1
x1
x1
[CONFIDENTIAL] 4-81