Volume Sensor Board - Toshiba QOSMIO G20 Maintenance Manual

4 Replacement Procedures

4.29 Volume sensor board

Removing the volume sensor board
The following describes the procedure for removing the volume sensor board (See Figure 4-
42).
1. Remove the following screws securing the volume sensor holder and remove the
volume sensor holder.
M2.5x2.8B
2. Draw the volume harness from the guide of cover assembly and remove the volume
sensor board from the cover assembly.
Volume harness
Installing the volume sensor board
The following describes the procedure for installing the volume sensor board (See Figure 4-
42).
1. Arranging the volume harness along the guide of cover assembly, install the volume
sensor board.
2. Install volume sensor holder and secure it with the following screws.
M2.5x2.8B
QOSMIO G20 Maintenance Manual (960-511)
FLAT BIND screw
Figure 4-42 Removing the volume sensor board
FLAT BIND screw
4.29 Volume sensor board
x2
M2.5x2.8B FLAT BIND
Volume sensor holder
Volume sensor board
x2
[CONFIDENTIAL] 4-67