Ej-08 Underhook; Breeze Break; Carrying Case - AND EJ-120 Instruction Manual

9-3. EJ-07 / EJ-08 Underhook
By attaching the underhook to the bottom of the balance, large objects that are difficult
to load on the weighing pan can be weighed, and the density (specific gravity) of
objects may be measured. Refer to "9-6. EJ-13 Density determination kit" for
information about density measurement.
EJ-07 is for use with the EJ-3000 / EJ-4100 / EJ-6100.
EJ-08 is for use with the EJ-1500 / EJ-2000.
Calibration, with the calibration weight hung from the underhook, is
required for accurate weighing.
EJ-07 / EJ-08 Installation
Open the cap on the bottom of the
balance, and screw the underhook
into the mounting hole.
Caution
Do not apply excessive force to the underhook.
When not in use, remove the underhook and attach the cap to prevent dust
from getting into the balance.
9-4. EJ-11 Breeze break
The EJ-11 Breeze break is mainly used for the 0.01 g minimum display models, but all
of the EJ series balances can use this option.
Remove the fixing frame.
Install the breeze break frame in place of
the fixing frame.
Attach the breeze break to the balance.
Fixing frame
9-5. EJ-12 Carrying case
The EJ-12 Carrying case is available for the convenience of carrying the balance by
hand. However, because the balances are precision equipment, dropping or rough
handling, even while in the carrying case, may damage them.
Remove
the cap.
EJ-07
Breeze break frame
26
EJ-08

Breeze break