Gravity Acceleration Correction - AND EJ-120 Instruction Manual

7-2. Gravity acceleration correction

When the balance is first used or has been moved to a different place, it should be
calibrated using a calibration weight.
But if a calibration weight is not available, the gravity acceleration correction will
compensate the balance. Change the gravity acceleration value of the balance to the
value of the area where the balance will be used. See the gravity acceleration map
appended to the end of this manual.
Note
Gravity acceleration correction is not required when the balance is
calibrated using a calibration weight at the place where the balance
is to be used.
1. Press and hold the calibration (CAL) switch until
Cal appears, and release the switch.
2. The balance displays Cal 0 .
3. Press the RE-ZERO key.
The display shows the gravity acceleration value
stored in the balance.
Use the following keys to change the value.
SAMPLE key
RE-ZERO key
PRINT key
UNITS key
4. After setting the value, press the PRINT key.
Cal 0
is displayed again.
5. If it is necessary to calibrate the balance using a
calibration weight, go to step 4 of 7-1.
To finish the setting, press the UNITS key.
6. end appears and the balance returns to the
weighing mode.
To select the digit blinking to be
changed.
To set the value of the digit
selected.
To store the value and return to
step 2.
To cancel the value and return to
step 2.
16
Press and hold
the CAL switch
Cal
Release the CAL switch
Cal 0
9. 7 985
Set the value using
the relevant keys
To store
Cal 0
Returns to
the weighing mode