Installation - Kelvinator KSV26CRE Installation Manual

Installation

Indoor electric wiring
Note: for correct operation of the air conditioner and standby
power modes the mains power should be supplied to the
indoor unit.
1. Open the front panel and remove the wiring cover by
loosening the screw.
2. Route the power connection cable from back of the indoor
unit and pull it toward the front through the wiring hole for
connection.
3. Connect and screw the wires onto the terminal block as
identified by their colours.
KSV26CRE, KSV35CRE models
N(1) 2
blue black brown
20 I nstallation instructions Kelvinator Air Conditioning
KSV26HRE, KSV35HRE models
wiring cover
4.
5.
6.
7.
All wires between indoor and outdoor units must be connected by
a qualified electric contractor.
earthing wire
If the length of the power cord is not enough, please contact your
(green & yellow)
installer for new a power cord. Lengthening the power cord by
yourself is dangerous and illegal.
cable clamp
Note: Powered accessories cannot be connected to these wiring
points
After tightening the screws, pull the wire slightly to confirm whether
to outdoor unit
it's firm or not.
Do not connect two power cables together to supply power to the
air conditioner.
Do not extend the power cable conductor by cutting or splicing.
N(1) 2
blue
black
brown
Wrap wires that are not connected with insulating tape so that
they do not touch any electrical or metal parts.
Secure the wires firmly with the cable clamp.
Put the wiring cover back and screw it.
Reinstall the front panel.
warning
4 5
earthing wire
(green and yellow)