Responding To Messages - Kyocera TASKalfa 1800 Operation Manual

Troubleshooting > Troubleshooting

Responding to Messages

If a problem has occurred in the machine, you will be notified by the following display.
• The [Attention] indicator on the operation panel is lit or flashing.
• An error message appears in the message display of the machine's operation panel.
If the [Attention] indicator is lit or flashing and an error message appears in the message display of the machine's
operation panel, check the KYOCERA Client Tool or Status Monitor.
NOTE
If the indicators light or flash repeatedly in manners not described above, a service error has probably occurred. Turn
off the power, unplug the power cord, and then plug the power cord back in and turn on the power. This may clear the
error. Even if the error is not cleared, contact your service representative.
Problems that can be resolved by the user are described below.
A
Message Display
Add toner.
C
Message Display
Call service.
Cannot duplex print on this
paper.
↑↓ (Displayed alternately)
OF II (paper size) Bond
(media type)
OK: Go next step
Clean the scanner.
Close the Document
processor.
Checkpoints
Toner is empty.
Checkpoints
―
Did you select a paper size/type that
cannot be duplex printed?
—
Is the document processor open?
Add toner.
Corrective Actions
Replace the toner container.
Corrective Actions
An error has occurred in the machine.
Make a note of the error code displayed
on the message display, and contact
your service representative.
Press the [OK] key to move to the next
step.
• Select [Select paper] to select the
other paper source.
• Select [Go without change] to print
without using Duplex function.
Clean the slit glass using the cleaning
cloth supplied with the document
processor.
Close the document processor.
9-11
Reference
Page
page 9-3
Reference
Page
―
―
page 9-2
—