Configuring Line Answering - Nortel CallPilot 100 Administration Manual

58 Chapter 5 Setting up the Auto Attendant

Configuring line answering

CallPilot can answer all of your incoming lines, or just the lines you specify. Before CallPilot can
answer an incoming line, you must assign the line and set the Answer status to Yes. Each line you
add is answered by Greeting Table 1, unless you specify another table.
To configure how a line is answered
Log:
QUIT RETRY
Admin
MBOX AA
Auto Atdt Admin
GRTG TABLE
Line number:
RETRY
Line:1 Ans:N
CHNG TABLE
Line:1 Ans:AA
CHNG TABLE
Line:1 Table:1
CHNG RINGS
Grtg table:
RETRY
Line:1 Table:1
CHNG RINGS
N0025636 02
Press ≤·°‹.
1
OK
Enter the System Administrator Mailbox number and password,
and then press OK.
Press AA.
2
OTHR
Press LINES.
3
LINES
Enter the number of the line you want to configure and press OK.
4
OK
Press CHNG to toggle the Answer status from N to AA.
5
NEXT
Press TABLE.
6
NEXT
Press CHNG.
7
NEXT
Enter a Greeting Table number from 1 to 4 and press OK.
8
OK
If you want to continue adding lines, press NEXT and repeat steps 5
9
NEXT
to 9
or
press ® to end the session.