Subaru 2002 IMPREZA Service Manual page 1901

Camber is increased.
Camber is decreased.
3) Tighten the two self-locking nuts.
Tightening torque:
175 N·m (17.8 kgf-m, 129 ft-lb)
3. CASTER
• Inspection
1) Place the front wheel on turning radius gauge.
Make sure ground contacting surfaces of front and
rear wheels are set at the same height.
2) Set the ST into the center of wheel, and then in-
stall the wheel alignment gauge.
ST 927380002 ADAPTER
(1) Alignment gauge
(2) Turning radius gauge
3) Follow the wheel alignment gauge operation
manual to measure caster angle.
NOTE:
Refer to the "SPECIFICATIONS" for caster values.
<Ref. to FS-2, SPECIFICATIONS, General De-
scription.>
WHEEL ALIGNMENT
Left side
Rotate counterclock-
wise.
B4M0190
Rotate clockwise.
B4M0350
4. STEERING ANGLE
• Inspection
1) Place the vehicle on a turning radius gauge.
2) While depressing the brake pedal, turn the steer-
ing wheel fully to the right and left. With the steering
wheel held at each fully turned position, measure
both the inner and outer wheel steering angle.
Steering angle:
• Adjustment
Turn the tie-rod to adjust steering angle of both in-
ner and outer wheels.
CAUTION:
• Check the toe-in.
• Correct the boot if it is twisted.
B4M0567B
FS-11
Right side
B4M0350
B4M0190
Turbo and OUT-
Model
BACK
34 ° ° ° ° 30 °± °± °± °± 1.5 ° ° ° °
Inner wheel
34 ° ° ° ° 30 °± °± °± °± 1.5 ° ° ° °
Outer wheel
(1) Lock nut
FRONT SUSPENSION
Rotate clockwise.
Rotate counterclock-
wise.
Others
37 ° ° ° ° 20 °± °± °± °± 1.5 ° ° ° °
32 ° ° ° ° 25 °± °± °± °± 1.5 ° ° ° °
S4M0348A