Select Lever - Subaru 2002 IMPREZA Service Manual

2. Select Lever

A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Move the select lever to "N" position.
4) Lift-up the vehicle.
5) Remove the rear exhaust pipe and muffler.
Non-turbo model with OBD
<Ref. to EX-11, REMOVAL, Rear Exhaust Pipe.>,
<Ref. to EX-12, REMOVAL, Muffler.>
Non-turbo model without OBD
<Ref. to EX(w/oOBD)-13, REMOVAL, Rear Ex-
haust Pipe.>, <Ref. to EX(w/oOBD)-14, REMOV-
AL, Muffler.>
Turbo model
<Ref. to EX(TURBO)-13, REMOVAL, Rear Ex-
haust Pipe.>, <Ref. to EX(TURBO)-14, REMOVAL,
Muffler.>
6) Remove the heat shield cover. (If equipped)
7) Disconnect the cable from select lever, and then
remove the cable bracket.
(A) Adjusting nuts
(B) Cable bracket
8) Lower the vehicle.
9) Remove the console box. <Ref. to EI-40, RE-
MOVAL, Console Box.>
10) Disconnect the connectors, then remove the
four bolts to take out the select lever assembly from
body.
SELECT LEVER
B: INSTALLATION
1) Mount the select lever onto the vehicle body.
2) Tighten the four bolts to install the select lever to
vehicle body, then connect the connector.
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
3) Install the console box. <Ref. to EI-38, INSTAL-
LATION, Glove Box.>
4) Set the location of select lever at "N" position.
5) Lift-up the vehicle.
6) Set the location of range select lever to "N" posi-
tion.
7) Insert the thread portion of the other inner cable
and into connector hole of the select lever, and fix
the other outer cable end to bracket.
Tightening torque:
18 N·m (1.8kgf-m, 13.0 ft-lb)
8) Adjust the select cable position. <Ref. to CS-10,
ADJUSTMENT, Select Cable.>
9) After completion of fitting, make sure that the se-
B3M1795A
lect lever operates smoothly all across the operat-
ing range.
10) Inspect the following items. If the following in-
spection reveals problems, adjust the select cable
and inhibitor switch. <Ref. to CS-10, ADJUST-
MENT, Select Cable.> and <Ref. to AT-28, AD-
JUSTMENT, Inhibitor Switch.>
(1) The engine starts operating when select le-
ver is in position "P", but not in other positions.
(2) The back-up light is lit when the select lever
is in position "R", but not in other positions.
(3) Select lever and indicator positions are
matched.
11) Install the heat shield cover. (If equipped)
B3M1510
CS-7
CONTROL SYSTEMS
B3M1796