Subaru 2002 IMPREZA Service Manual page 1798

MAIN SHAFT ASSEMBLY FOR SINGLE-RANGE
MANUAL TRANSMISSION AND DIFFERENTIAL
8) Install the baulk ring and synchro cone onto 5th-
Rev sleeve and hub assembly using ST and a
press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
NOTE:
• Use a new ball bearing.
• After press fitting, make sure the synchro cone
rotates freely.
ST 499757002 INSTALLER
(A) Baulk ring
(B) Synchro cone
(C) Ball bearing
9) Install the synchro cone stopper and snap ring to
5th-Rev sleeve and hub assembly.
(A) Synchro cone stopper
(B) Snap ring
10) Install the rest parts to the rear section of trans-
mission main shaft.
NOTE:
Align the groove in baulk ring with shifting insert.
B3M1370A
11) Tighten the lock nuts to the specified torque us-
ing ST1 and ST2.
NOTE:
Secure the lock nuts in two places after tightening.
ST1 499987003
ST2 498937000
Tightening torque:
118 N·m (12.0 kgf-m, 86.8 ft-lb)
B3M0435B
MT-74
(A) Needle bearing
(B) 5th drive gear
(C) Baulk ring
(D) 5th-Rev sleeve and hub ASSY
(E) Lock washer
(F) Lock nuts
SOCKET WRENCH
TRANSMISSION HOLDER
B3M1371A