Subaru 2002 IMPREZA Service Manual page 2398

POWER ASSISTED SYSTEM (POWER STEERING)
13) Carefully draw out the input shaft, and then re-
move the valve assembly.
14) Using a sharp pointed pliers, rotate the rack
stopper in direction of the arrow until end of the cir-
clip comes out of stopper. Rotate the circlip in op-
posite direction and pull it out.
(1) Rack stopper
15) Pull the rack assembly from cylinder side, and
draw out the rack bushing and rack stopper togeth-
er with the rack assembly.
CAUTION:
Be careful not to contact the rack to inner wall
of cylinder when drawing out. Any scratch on
the cylinder inner wall will cause oil leakage.
(1) Rack bushing
(2) Rack assembly
(3) Rack stopper
STEERING GEARBOX [LHD MODEL]
S4M0155
S4M0158B
S4M0402A
PS-36
16) Remove the rack bushing and rack stopper
from rack assembly.
CAUTION:
Do not reuse the removed rack bushing and cir-
clip.
17) Remove the oil seal from rack.
18) Insert the ST from pinion housing side, and
then remove the oil seal using a press.
ST 34099FA110 INSTALLER
(1) Press
(2) Oil seal
NOTE:
Discard the removed the oil seal.
S4M0163B