Subaru 2002 IMPREZA Service Manual page 1830

MANUAL TRANSMISSION AND DIFFERENTIAL
5) Install the interlock plunger onto 3-4 fork rod.
NOTE:
Apply a coat of grease to plunger to prevent it from
falling.
6) Install the 3-4 fork rod into 3-4 shifter fork via the
hole on the rear of transmission case.
7) Align the holes in rod and fork, and new drive
straight pin into these holes.
NOTE:
• Set the reverse fork rod to neutral.
• Make sure the interlock plunger (installing be-
fore) is on the reverse fork rod side.
ST 398791700 STRAIGHT PIN REMOVER
8) Install the 5th shifter fork onto the rear of reverse
fork rod. Align holes in the two parts and new drive
straight pin into place.
ST 398791700 STRAIGHT PIN REMOVER
(A) 5th shifter fork
(B) Reverse fork rod
(C) Straight pin
9) Position the balls, checking ball springs and new
gaskets into 3-4 and 1-2 rod holes, and install
plugs.
(A) 5th shifter fork
(B) Reverse fork rod
(C) Straight pin
10) Install the differential assembly. <Ref. to MT-
95, INSTALLATION, Front Differential Assembly.>
SHIFTER FORK AND ROD
11) Install the main shaft assembly.
Single-range model
<Ref. to MT-68, INSTALLATION, Main Shaft As-
sembly for Single-Range.>
Dual-range model
<Ref. to MT-76, INSTALLATION, Main Shaft As-
sembly for Dual-Range.>
12) Install the drive pinion shaft assembly. <Ref. to
MT-86, INSTALLATION, Drive Pinion Shaft As-
sembly.>
13) Install the transmission case. <Ref. to MT-63,
INSTALLATION, Transmission Case.>
14) Install the transfer case with extension case as-
sembly. <Ref. to MT-48, INSTALLATION, Transfer
Case and Extension Case Assembly.>
15) Install the back-up light switch and neutral po-
sition switch. <Ref. to MT-44, INSTALLATION,
Switches and Harness.>
16) Install the manual transmission assembly to ve-
hicle. <Ref. to MT-37, INSTALLATION, Manual
Transmission Assembly.>
B3M0333J
B3M0333J
MT-106