Subaru 2002 IMPREZA Service Manual page 1574

AUTOMATIC TRANSMISSION
16.Control Valve Body
A: REMOVAL
1) Lift-up the vehicle.
2) Clean the transmission exterior.
3) Drain the ATF completely.
NOTE:
Tighten the ATF drain plug after draining the ATF.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(A) Oil pan
(B) Drain plug
(C) Differential oil drain plug
4) Remove the oil pan.
NOTE:
• Remove and clean the magnet.
• Remove the old gasket on the oil pan and trans-
mission case completely.
CONTROL VALVE BODY
5) Disconnect the duty solenoids and ATF temper-
ature sensor connectors. Remove the connectors
from clip and disconnect the connectors.
B3M1036B
6) Remove the control valve.
NOTE:
When removing the control valve body, be careful
not to interfere with transfer duty solenoid wiring.
AT-38
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
(J) Transmission ground
B2M2263I
B3M1037