Subaru 2002 IMPREZA Service Manual page 1529

7) Draw out the spring pin, then remove the bush A
from gear shift lever.
(A) Spring pin
(B) Bush A
D: ASSEMBLY
1) Clean all parts before assembly.
2) Mount the bush and cushion rubber on the stay.
(A) Bush
(B) Cushion rubber
MT GEAR SHIFT LEVER
3) Mount each part; boot, O-ring, bush A, spacer,
bush B, bush and spring pin on the gear shift lever.
NOTE:
• Always use new O-rings.
• Apply grease [DNIGTIGHT LYW No. 2 or equiv-
alent] to the inner and side surfaces of the bush
when installing the spacer.
B3M0621B
4) Insert the gear shift lever into boot hole.
5) Install the snap ring and stay to bush B.
B3M0830C
CS-15
(A) Boot
(B) O-ring
(C) Bush
(D) Spacer
(E) Bush A
(F) Bush B
(G) Spring pin
(H) O-ring
(A) Snap ring
(B) Bush B
CONTROL SYSTEMS
B3M0623C
B3M0619C