Subaru 2002 IMPREZA Service Manual page 1568

AUTOMATIC TRANSMISSION
13.Front Vehicle Speed Sensor
A: REMOVAL
1) Set up the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Remove the air cleaner case. (Non-turbo model)
<Ref. to IN-6, REMOVAL, Air Cleaner Case.>
4) Remove the intercooler. (Turbo model)
<Ref. to IN(TURBO)-10, REMOVAL, Intercooler.>
5) Disconnect the transmission connector.
(A) Transmission connector
6) Remove the pitching stopper. <Ref. to AT-25,
REMOVAL, Transmission Mounting System.>
7) Remove the transmission connector from stay.
8) Lift-up the vehicle.
9) Clean the transmission exterior.
FRONT VEHICLE SPEED SENSOR
G6M0095
S3M0039B
AT-32
10) Drain the ATF completely.
NOTE:
Tighten the ATF drain plug after draining the ATF.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(A) Oil pan
(B) Drain plug
(C) Differential oil drain plug
11) Remove the front, center, exhaust pipes and
muffler. (Non-turbo model)
<Ref. to EX(w/oOBD)-9, REMOVAL, Front Exhaust
Pipe.>, <Ref. to EX(w/oOBD)-13, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(w/oOBD)-14, RE-
MOVAL, Muffler.> or <Ref. to EX-7, REMOVAL,
Front Exhaust Pipe.>, <Ref. to EX-11, REMOVAL,
Rear Exhaust Pipe.> and <Ref. to EX-12, REMOV-
AL, Muffler.>
12) Remove the center, rear exhaust pipe and muf-
fler. (Turbo model)
<Ref. to EX(TURBO)-8, REMOVAL, Center Ex-
haust Pipe.>, <Ref. to EX(TURBO)-13, REMOVAL,
Rear Exhaust Pipe.> and <Ref. to EX(TURBO)-14,
REMOVAL, Muffler.>
13) Remove the shield cover. (If equipped)
14) Remove the propeller shaft. <Ref. to DS-15,
REMOVAL, Propeller Shaft.>
15) Place the transmission jack under transmis-
sion.
NOTE:
Make sure that the support plates of transmission
jack don't touch the crossmember.
B3M1036B