Honeywell Ademco Vista-12D Installation And Setup Manual page 75

*81 Menu Mode
PROMPT
Zone List No.
(00 = Quit) 01
01 Enter Zn Num.
(00 = Quit) 00
01 Del Zn List?
0 = No 1 = Yes 0
01 Delete Zone?
0 = No 1 = Yes 0
01 Zn to Delete?
(00 = Quit) 00
Notes:
• Any list may include any or all of the system's zone numbers.
• A zone list can be assigned to more than one output relay.
• When creating zone list 4 for linked zones, include only zones assigned to zone types 3, 4,
or 5. Do not include zones that have delays (entry/exit zones, interior w/delay) or 24-hour
zones, as these zone types may produce unpredictable operation and may not function as
intended.
VALID ENTRIES
Zone List Number
01-12 = zone list number
[∗] to continue
Zone Number
01-06, 9-24, 49-64 = zone
numbers followed by [∗] to
accept each zone
00 to continue
Deleting Zone Lists
0 = don't delete list
1 = delete this zone list
[∗] to continue
Deleting a Zone
0 = don't delete zones
1 = go to next prompt to delete
zones
[∗] to continue
Delete the Zone
01-06, 9-24, 49-64 zones to be
deleted from list followed
by [∗] to accept each zone
00 to continue
EXPLANATION
Enter the Zone List Number to program (or 00 to
end these entries). Press [ ∗ ] to advance.
In the following displays, zone list 01 has been
selected for programming.
Enter each zone number to add to the zone list,
followed by pressing [ ∗ ] (example, 01 ∗ , 02 ∗ , 03 ∗ ).
After all zones are entered, press 00 to continue.
IMPORTANT: Do not include fire zones in zone
lists that are used to STOP device actions.
To delete the zone list, enter 1. All zones in the
zone list will be deleted automatically and the
system returns to the Zone List No. prompt.
To save the zone list, enter 0.
To save the entire zone list, enter 0 and the
system returns to the Zone List No. prompt.
To delete a zone or zones in a zone list enter 1 to
continue.
Enter each zone to be deleted from the list,
followed by [ ∗ ]. After all zones to be deleted are
entered, enter 00 to return to the Zone List No.
prompt. so that another list can be programmed, if
desired.
5-19