Honeywell Ademco Vista-12D Installation And Setup Manual page 92

Installation and Setup Guide
Keypad Commands (cont'd.)
Arming Away
Arming Stay
Arming Night-Stay
Arming Instant
Arming Maximum
Disarming
Bypassing Zones
Forced (Quick) Bypass
Chime Mode
Activate Output Devices
6-8
Enter code + AWAY [2] or simply press appropriate lettered key on the
keypads (see "Single-Button Arming" above). If the "Auto-Stay Arm"
feature is enabled and the entry/exit door is not opened and closed
within the programmed exit delay time, the system will automatically
arm in STAY mode if armed from a wired keypad (non-RF device). If the
door is opened and closed within the exit delay period, the system arms
in AWAY mode.
Enter code + STAY [3] or simply press appropriate key on the keypads
(see "Single-Button Arming" above). See "Arming Away" above for Auto-
Stay arming feature.
Enter code + STAY [3] + STAY [3] or simply press appropriate key on the
keypads (see "Single-Button Arming" above).
Enter code + INSTANT [7].
Enter code + MAXIMUM [4] or simply press appropriate lettered key on
the keypads (see "Single-Button Arming" above).
Enter code + OFF [1]. If entry delay or an alarm is active, you do not
need to press OFF; entering the security code alone disarms the system.
Enter code + BYPASS [6] + zone number(s). Can bypass while system
armed/disarmed.
To automatically bypass all faulted zones, use the "Quick Bypass"
method. Enter code + BYPASS + [#], then wait for all open zones to be
displayed. Arm when display indicates "ZONE BYPASSED" and
"READY TO ARM".
Enter code + CHIME [9]. To turn chime off, enter code + CHIME again.
If relay outputs (via a 4204, 4229, or 6164), or Powerline Carrier devices
are used, two keypad entries available to the user are included. If
programmed, these entries can be used to manually activate or
deactivate the device(s) for starting or stopping some action, such as
turning lights on or off, etc. These keypad entries are:
[Security Code] + # + 7 + [2-digit Device #] activates (starts) that device.
[Security Code] + # + 8 + [2-digit Device #] deactivates (stops) that
device.