Menu Mode Programming; About Zone Programming (∗56 And ∗58 Menu Modes); ∗ ∗ ∗ ∗ 56 Zone Programming Procedure - Honeywell Ademco Vista-12D Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
About Zone Programming (∗ ∗ ∗ ∗ 56 and ∗ ∗ ∗ ∗ 58 Menu Modes)
∗
56 Zone Programming is used to program zones, zone types, report codes, enroll 5800 RF
Wireless Transmitter serial numbers, and identify the type of loop input device(s). This mode
can also be used to enter alpha descriptors for programmed zones; however, we recommend
entering descriptors in menu mode
programming has been completed).
For a faster method of zone programming, you can use the
∗
instead of 56 Zone programming. The
who have had previous experience in programming control panels of this type.
NOTE: Alpha display prompts are shown in a double-line box.
∗ ∗ ∗ ∗ 56 Zone Programming Procedure
Zone Programming involves:
1. Entering the zone number to be programmed;
2. Making appropriate entries at the prompts;
3. Confirming the serial number of wireless transmitter zones.
Start Zone Programming mode by pressing
following prompts are displayed:
PROMPT
SET TO CONFIRM?
0 = NO 1 = YES

Menu Mode Programming

∗
82 (Alpha Descriptor Programming after all zone
∗
58 Expert Programming Mode is designed for those
∗
56 while in Data Programming mode. The
VALID ENTRIES
Set to Confirm
0 = no
1 = yes
S E C T I O N
∗
58 Expert Programming Mode
EXPLANATION
If 1 (Yes) is entered, the XMIT TO CONFIRM
prompt appears later in this procedure after
entering RF transmitter serial and loop numbers,
and lets you confirm the programming of each RF
transmitter. We recommend that you confirm
every transmitter.
If 0 (No) is entered, the XMIT TO CONFIRM
prompt is automatically skipped.
This option is ignored if programming wired zones
only.
5
5-1