Connecting To A Module - Cisco Nexus 9504 Hardware Installation Manual

Managing the Switch
A threshold value of –127 indicates that no thresholds are configured or applicable.
Note
Use the show environment temperature command to display the temperature readings for each of the
powered-up modules.
switch# show environment temperature
Temperature:
--------------------------------------------------------------------
Module
--------------------------------------------------------------------
4
4
4
4
4
4
4
22
22
22
22
22
27
27
27
28
28
28
29
30
switch#

Connecting to a Module

You can connect to any module by using the attach module slot_number command. When the the module
prompt appears, you can obtain further details about the module by using module-specific commands in EXEC
mode.
You can also use the attach module command to display the standby supervisor module information, although
you cannot configure the standby supervisor module using this command.
Note To see which slots are filled with modules, use the show inventory command.
Use the attach module slot_number command to get direct access to a specific module.
This example shows how to attach to the supervisor in slot 28.
switch# attach module 28
Attaching to module 28 ...
Tip We recommend that you install dual supervisor modules. If you are using a switch
without dual supervisor modules, we recommend that you immediately replace the fan
module if just one fan is not working.
Sensor MajorThresh
(Celsius)
CPU 105
TD2-1 105
TD2-2 105
TD2-3 105
VRM-1 110
VRM-2 110
VRM-3 110
CPU 105
TD2-1 105
TD2-2 105
VRM-1 110
VRM-2 110
OUTLET 75
INLET 60
CPU 90
OUTLET 75
INLET 60
CPU 90
CPU 105
CPU 105
MinorThres CurTemp
(Celsius) (Celsius)
95 32
95 41
95 41
95 41
100 41
100 45
100 40
95 34
95 45
95 41
100 49
100 47
55 29
42 20
80 27
55 27
42 22
80 33
95 40
95 34
Cisco Nexus 9504 NX-OS Mode Switch Hardware Installation Guide

Connecting to a Module

Status
Ok
Ok
Ok
Ok
Ok
Ok
Ok
Ok
Ok
Ok
Ok
Ok
Ok
Ok
Ok
Ok
Ok
Ok
Ok
Ok
45