Yamaha TW125 1999 Service Manual page 42

1 Battery positive lead
2 Starter relay
3 Starter motor lead
4 Clamp
5 Front brake switch lead
6 Handlebar switch lead (right)
7 Ignition coil
8 Horn lead
9 High tension cable
Flasher relay
10
Rear brake switch lead
11
Neutral relay
12
CDI unit
13
CABLE ROUTING
A The end of the plastic locking tie
must face down ward.
B Fasten the wire harness, han-
dlebar switch lead (right), front
brake switch lead, throttle cable,
starter cable, clutch switch lead
and main switch lead to the
frame with steel clamp.
C Route the wire harness, handle-
bar switch (right) and front brake
switch lead through the cable
guide.
D Route the battery breather hose
through the cable guide.
2-20
SPEC
E Route the battery breather hose
through the hole of air cleaner
case.
F Fasten the rear brake switch
lead couplers and carburetor
heater lead to the frame with a
plastic locking tie.
The end of the plastic locking tie
must face front side.