Yamaha TW125 1999 Service Manual page 130

CLUTCH
5. Install:
S friction plates
S clutch plates
NOTE:
First, install a friction plate and then alternate
between a clutch plate and a friction plate.
6. Install:
S long clutch push rod
S ball
7. Install:
S short clutch push rod 1
S O-ring 2
New
S push plate 3
S washer 4
S nut 5
8. Install:
S pressure plate 1
S clutch springs 2
S clutch spring bolts 3
NOTE:
Tighten the clutch spring bolts in stages and in a
crisscross pattern.
9. Check:
S push lever position
Push lever mark a and crankcase mark b
not aligned ! Correct.
NOTE:
Push the push lever in direction c and make
sure that the marks are aligned.
10. Adjust:
S push lever position
a. Loosen the locknut 1 .
b. Turn the adjusting screw 2 in or out until the
marks are aligned.
c. Hold the adjusting screw to prevent it from
moving and then tighten the locknut to speci-
fication.
4-36
ENG
6 Nm (0.6 mSkg)