Lock Washers/Plates And Cotter Pins; Bearings And Oil Seals; Circlips - Yamaha TW125 1999 Service Manual

OR
IMPORTANT INFORMATION
EAS00023
LOCK WASHERS/PLATES AND COTTER
PINS
1. After removal, replace all lock wash-
ers/plates 1 and cotter pins. After the bolt or
nut has been tightened to specification, bend
the lock tabs along a flat of the bolt or nut.
EAS00024

BEARINGS AND OIL SEALS

1. Install bearings and oil seals so that the
manufacturer's marks or numbers are vis-
ible. When installing oil seals, apply a light
coat of lithium soap base grease onto the oil
seal lips. Oil bearings liberally when instal-
ling, if appropriate.
1 Oil seal
CAUTION:
Do not spin the bearing with compressed air
because this will damage the bearing sur-
faces.
1 Bearing
EAS00025

CIRCLIPS

1. Before reassembly, check all circlips careful-
ly and replace damaged or distorted circlips.
Always replace piston pin clips after one use.
When installing a circlip 1 , make sure that
the sharp-edged corner 2 is positioned op-
posite the thrust 3 that the circlip receives.
4 Shaft
1-3
GEN
INFO