Table of Contents
Advertisement
Each transmitter has an individually assigned, unique ID code. In order to start operation, the
receiver must be linked with the ID code of the transmitter with which it is being paired. Once
the link is made, the ID code is stored in the receiver and no further linking is necessary unless
the receiver is to be used with another transmitter. When you purchase additional receivers, this
procedure is necessary; otherwise the receiver will not work.
1
Place the transmitter and the receiver
close to each other within 20 inches (half
meter).
2
To activate the "Link Mode".
Operate both sticks fully in the
bottom and the inside, in the
power off state.
3
Immediately turn on the receiver power.
The receiver will enter the linking state
(LED blinks red) about 3 seconds after
the receiver power is turned on.
4
The LED changed from red to a steady green light, linking is complete.
(A linking process is ended in 15 seconds.)
5
Check system operation. If the transmitter and receiver are not linked, try linking again.
*If there are many T-FHSS Air systems turned on in close
proximity, your receiver might have difficulty establishing a link
to your transmitter. This is a rare occurrence. However, should
another T-FHSS Air transmitter/receiver be linking at the same
time, your receiver could link to the wrong transmitter. This is
very dangerous if you do not notice this situation. In order to
avoid the problem,we strongly recommend you double check
whether your receiver is really under control by your transmitter.
* The R3106GF uses the T-FHSS Air ( Mono directional) system
so if used with another T-FHSS Air transmitter, then the ID of
the R3106GF receiver will not be shown on the transmitter's dis-
play. A "NO LINK" indication or the ID of a previously linked
T-FHSS Air receiver will be shown. Nevertheless, if the LED
on the R3106GF displays a steady green light it is linked with a
transmitter. (Telemetry can not be used on the R3106GF.)
LINK PROCEDURE
Turn on the power switch.
In "Link" Mode
Less than 20 inches
Transmitter in
"Link Mode"
Transmitter LED blinking
Once 1s ON - Once 1s OFF
Enters the link mode
for 15 seconds
Receiver ON
WARNING
After the linking is done, please cy-
cle receiver power and check that
the receiver to be linked is really un-
der the control of the transmitter.
Don't perform the linking procedure
with motor's main wire connected or
with the engine operating as it may
result in serious injury.
17
Advertisement
Table of Contents
