Engine Servicing - 8000 - Arctic Cat 2014 M 2-STROKE Service Manual

2014
Table of Contents

Advertisement

Engine Servicing - 8000

This engine sub-section has been organized to show a
progression for servicing of the Arctic Cat 8000 engine.
For consistency purposes, this sub-section shows a com-
plete and thorough progression; however, for efficiency it
may be preferable to disassemble only those components
needing to be addressed. Also, some components may
vary from model to model. The technician should use
discretion and sound judgment.
SPECIAL TOOLS
A number of special tools must be available to the technician
when performing service procedures in this engine section.
Description
Ball Hone
Flywheel Spanner Wrench
Flywheel Puller
Flywheel Puller Insert
Extractor Nut (Medium)
Oil Seal Protector Tool
Piston Pin Puller
Surface Plate
Water Pump Bearing and Seal Tool Kit
V Blocks
Vacuum Test Pump
 NOTE: Special tools are available from the Arctic
Cat Service Parts Department.
Disassembling
 NOTE: When disassembling top-side components,
mark MAG-side and PTO-side components for assem-
bling purposes.
1. Using the Flywheel Spanner Wrench to secure the
flywheel, remove the flywheel cap screw and
washer; then remove the three starter clutch cap
screws and remove the clutch.
2. Install the Flywheel Puller Insert onto the end of the
crankshaft.
p/n
0644-294
0144-007
0744-040
0644-568
0643-074
0644-219
0644-328
0644-016
0644-557
0644-535
0644-131
3. Using Flywheel Puller or suitable substitute, remove
the flywheel from the crankshaft by tightening the
puller bolt, striking the head of the puller bolt with a
hammer, and tightening again. Repeat this procedure
until the flywheel is free. Account for the key.
To prevent damage to the crankshaft, do not thread
puller bolts more than 1/2 in. into the flywheel. Damage
to the coils may result.
 NOTE: To ensure the cleanliness of the flywheel
magnets, place the flywheel (with the magnets facing
upward) on a clean bench.
CM138
4. Remove the cap screw securing the ground wire to
the crankcase.
CAUTION
CM139
IO013
CM140
59

Advertisement

Table of Contents
loading

This manual is also suitable for:

2014 zr 2-stroke2014 xf 2-stroke

Table of Contents