Arctic Cat 2014 M 2-STROKE Service Manual page 41

8. Remove the caps screws securing the PTO-side front
spar to the steering support and shock mount bracket;
then remove the spar.
 NOTE: Take care to not drop the spar inserts and
nuts when removing the spar.
9. Using a small needle-nose pliers, remove the servo-
motor cable holder; then pull the cable housings
down and out of the servomotor.
10. Slide each cable end out of the slot of the clutch; then
disconnect the connector from the servomotor.
11. Remove the lock nuts securing the shock mount
bracket support to the shock mount brackets; then
remove the shock mount bracket support.
38
PC188A
12. Drain the engine coolant (see Liquid Cooling System
- the Engine-Related Items section).
13. Loosen the clamp securing the gasline hose to the
throttle body and remove the hose; then close-off the
hose and secure the hose up and out of the way.
The hose may be under pressure; remove it slowly to
release the pressure. Place an absorbent towel around
PC187A
the connection to absorb gas.
14. Loosen the clamps securing the air intake boot to the
throttle bodies and pull the air intake boot forward
enough to gain access to the throttle body assembly.
Remove and retain the clamps.
15. Loosen the flange clamps securing the throttle body
assembly to the intake flanges and disconnect the oil-
injection control rod from the throttle body; then
loosen the clamps securing the throttle body coolant
hoses. Disconnect the TPS and move the throttle
body assembly forward and out of the way.
PC134
! WARNING
PC186A
PC135A
PC138A