Arctic Cat 2014 M 2-STROKE Service Manual page 23

 NOTE: At this point if the technician's objective is to
remove the steering arm, the reinforcement bracket
will need to be removed by drilling out the appropri-
ate rivets.
6. Remove all torx-head screws securing the front skid
plate to the chassis; then remove the cap screw and
nut securing the steering arm to the chassis. Account
for two washers and two bushings.
INSPECTING
1. Inspect the ball joints for damaged threads or wear.
2. Inspect the tie rod for damage, unusual bends, or
wear.
INSTALLING
1. Secure steering arm into position and secure using
the existing cap screw, flat washers, and nut. Tighten
to 96 in.-lb.
20
2. Place the steering tie rod into position on the steering
post. Secure with a new nyloc nut. Tighten to 35 ft-
lb.
PC099C
 NOTE: Make sure the tie rod tab is fully seated into
the steering post and threads of the ball joint are
above the nut when tightened correctly.
3. Place the tie rod end into position on the steering tie
rod bracket. Secure with a new nyloc nut. Tighten to
20 ft-lb.
SNO-225A
4. Slide the steering tie rod through the steering boot
and into the snowmobile; then place the steering tie
rod into the spindle arm with the washer. Secure
with a new nyloc nut. Tighten to 32 ft-lb.
5. Secure the steering tie rod to the steering tie rod
bracket with the screw and new nyloc nut. Tighten to
20 ft-lb.
SNO-225A
SNO-351
SNO-350
SNO-353